Titanium trichloride
TiCl₃Also called α-TiCl₃, titanium(III) chloride
- Thickness
- ~0.59 nm per layer
- Stability
- Pyrophoric: inert gas only
- Most mature use
- lab
In titanium trichloride the magnetism switches itself off as the crystal cools. Each Ti3+ ion carries a single d electron, and below about 217 K neighbouring titanium ions pair up: the honeycomb distorts, the magnetic susceptibility drops sharply and neutron diffraction finds no magnetic order, which Ogawa explained in 1960 by the two electrons of each pair forming a Ti–Ti bond. MoCl3 pairs more strongly still and is thought to be non-magnetic for the same reason. α-TiCl3 is also a well-established Ziegler–Natta catalyst for polymerising ethylene, and sheets of it grown thin on a substrate are more active than the bulk.
Crystal structure
They are coordination polyhedra. Only complete ones are drawn.
Three layers of α-TiCl3 stacked as in BiI3: each layer is shifted by the same step in the same direction, so the pattern repeats only after three layers: c = 17.60 Å, 5.87 Å from layer to layer. Crystals that repeat after two layers (P-31c) are also known. Below about 217 K the titanium pairs up and the stacking turns monoclinic. Cell and layer from Troyanov and colleagues, Zhurnal Neorganicheskoi Khimii 36, 1117 (1991); COD 1535644.
- Cl
- Ti
- Cell
- Hexagonal, a = 6.15 Å
- Atoms per cell
- 8
- Ti–Cl bond
- 2.42 Å
- Height
- 2.76 Å between the outer atom centres
Key properties
- Below about 217 K neighbouring Ti3+ ions, each with a single d electron, pull into pairs: the Ti–Ti distances of the honeycomb, 3.55 Å above the transition, split into 3.36 and 3.59 Å at 160 K, and the crystal turns monoclinic
- At the transition the magnetic susceptibility drops sharply, and neutron diffraction finds no magnetic order at low temperature
- Optical absorption changes at 217 K, both in the bands within the Ti3+ ions (1.2–2.1 eV) and in the charge-transfer bands above them
- Two layered stackings are known, a three-layer rhombohedral one (R-3) and a two-layer trigonal one (P-31c); other forms of TiCl3 consist of chains of face-sharing octahedra
- A well-established Ziegler–Natta catalyst for polymerising ethylene: microsheets about 4 µm thick grown on zirconia are 16% more active than bulk, and up to 24% after delamination to below 200 nm
- Calculations for a single layer predict a ferromagnetic half-metal with a Curie temperature estimated at up to 376 K; untested, and at odds with the pairing that removes the moments in bulk crystals
How it is made
- Microsheets about 4 µm thick straight onto yttria-stabilised zirconia, by short chemical vapour transport from 700 to 600 K with GaCl3 added as a transport aid, the conditions planned by thermodynamic simulation
- Delamination of these microsheets to below 200 nm
Uses, and how close they are
- Ziegler–Natta catalysis: α-TiCl3 is an established catalyst for polyethylene, and vapour-grown microsheets were 16% more active than bulk, up to 24% after delaminationlab
Readiness runs lab → prototype → pilot → deployed.
Open problems
- Does the Ti–Ti pairing of bulk TiCl3 survive in thin flakes, and what does a single layer do instead?
- Which low-temperature structure is right, the monoclinic one first reported or the triclinic one found later? And how do the pairs line up from one layer to the next?
Going deeper
Short notes for specialists. Choose a lens in the header and yours comes first.
The simplest honeycomb trihalide, with one d electron per titanium. Rather than order magnetically, neighbouring ions pair up below 217 K and their moments disappear, as they do, more strongly, in MoCl3. A model therefore needs the lattice as well as the spins, since the pairing distorts the honeycomb. Calculations for a single layer give a ferromagnetic half-metal instead; whether the pairing survives in one layer decides between the two pictures.
The 217 K transition shows up as a sharp drop in the magnetic susceptibility, as a lower-symmetry cell in diffraction, and in optical absorption, in both the crystal-field and the charge-transfer bands; neutron diffraction finds no magnetic order below it. The dry powder ignites in air and moisture decomposes it, so samples are prepared and sealed under inert gas.
No magnetic order, so no magnetic uses. Its practical role is chemical: α-TiCl3 is a Ziegler–Natta catalyst component, and sheets grown thin by vapour transport have proved more active than bulk crystals: a case where making a layered crystal thinner pays off directly.
Key references
- Crystal and magnetic structures in layered, transition metal dihalides and trihalidescited by 482doi:10.3390/cryst7050121
- Magnetic transition in TiCl3cited by 49doi:10.1143/JPSJ.15.1901
- Magnetic study of a phase transition at 217 K in α-TiCl3cited by 3doi:10.1016/S0304-8853(10)80063-0
- X-ray diffraction study of phase transition in α-TiCl3
- Optical properties of α-TiCl3 at the magnetic transition temperaturecited by 17doi:10.1002/pssb.2220450204
- The different crystalline modifications of TiCl3, a catalyst component for the polymerization of α-olefinscited by 183doi:10.1002/pol.1961.1205115602
- Layered α-TiCl3: microsheets on YSZ substrates for ethylene polymerization with enhanced activitycited by 9doi:10.1021/acs.chemmater.9b01818
- Evidencing the existence of exciting half-metallicity in two-dimensional TiCl3 and VCl3 sheetscited by 101doi:10.1038/srep19407
Download these references as BibTeX or RIS for Zotero, EndNote or Mendeley.